Installing and Configuring: Basic Concepts
As seen in DIRAC Setup Structure, DIRAC provides you with several components, these components are organized in systems, and these components can be installed in a DIRAC Server Installation using the System Administrator Console.
The components don’t need to be all resident on the same host, in fact it’s common practice to have several hosts for large installations.
Normally, services are always exposed on the same port, which is defined in the configuration for each of them.
in the near future the services are planned to run on one port, see HTTPS Services with Tornado and some services already run on one port, by default on 8443
As a general rule, services can be duplicated, meaning you can have the same service running on multiple hosts, thus reducing the load. There are only 2 cases of DIRAC services that have a “master/slave” concept, and these are the Configuration Service and the Accounting/DataStore service. The WorkloadManagement/Matcher service should also not be duplicated.
Same can be said for executors: you can have many residing on different hosts.
The same can’t be said for agents. Some of them can be duplicated, BUT require a proper configuration, and for this you need to read further in the guide (See scalingLimitations).
Each component has a configuration
When you install a component, it comes with a default configuration. The configuration is available to all the components via the Configuration Service, and its content is exposed by the “Configuration Manager” application in the DIRAC web portal.
The next section, DIRAC Configuration keeps a reference of the configuration for each of the components. You don’t need to read it all now, you just need to know it’s there.
What to install
Some components will be needed, whatever you do, e.g. as it should be clear already, you will need always the Configuration Service.
And almost certainly, a large part of what is part of DIRAC framework (the FrameworkSystem) is needed.
Then, it depends from what you want to do. So, if you just want to run some jobs, you’d need to install WorkloadManagementSystem components. If you need to do something else… then, again, it depends.
You need to keep reading.